Scratching and scurrying in walls at night
We map the run with a thermal imaging camera, set traps on the active path, and seal the entry points feeding that void. Most customers stop hearing scratching within 48 hours of the first visit.
Mice Control Burleson TX means finding where rodents are getting in, trapping the ones already inside, and sealing the gap so the next family can't follow. We handle mouse removal in Burleson TX for homes and businesses across Johnson County, from attic runs in Old Town to garage corners near 76028. If you're hearing scratching after dark, call (817) 426-4375.

Mice Control Burleson TX is the licensed inspection, trapping, exclusion, and sanitation work that clears a mouse infestation from a structure and keeps it from returning. A house mouse needs a gap the width of a pencil to get inside, and it will gnaw through insulation, wiring, and drywall to reach food and warmth. We inspect the whole envelope, set rodent traps and bait stations where the trail runs, seal every entry point we find, and clean up the mess they leave behind.
Burleson sits between Fort Worth and the Johnson County line, and the mix of older pier-and-beam homes near Old Town and newer slab builds off 76097 gives mice two very different ways in. When the first cold snap hits in November, field mice push indoors looking for warmth, and a garage or attic that stayed quiet all summer turns into a nightly run. That's when most people start searching for mice control near me Burleson TX, usually after they've already found droppings in a kitchen drawer.
Every job starts with a full inspection and ends with a verified follow-up. The inclusions below are standard on residential mice control. Larger commercial properties and homes with heavy attic contamination get a custom scope after the inspection.
We check the attic, crawlspace, garage, kitchen, and exterior foundation line. Droppings, rub marks, and gnaw damage get documented so you know exactly what we found and where.
Snap traps and glue boards go on the active run, not scattered along baseboards. We map the trail with a thermal imaging camera first so the traps are where the mice actually travel.
Copper mesh, hardware cloth, and sealant close gaps around pipes, vents, and foundation lines. Most Burleson homes have 6 to 12 openings, and we seal every one we find.
Contaminated insulation and droppings get bagged and hauled out. We apply a disinfectant rated for rodent waste so the attic or crawlspace is safe to enter again.
We return two weeks out to pull traps, check the sealed points, and confirm the activity has stopped. If mice got back in through a sealed gap, we re-treat at no charge.
A licensed technician walks the interior and exterior, checking the attic, crawlspace, garage, and kitchen. We look for droppings, grease rub marks, gnawed wiring, and entry gaps. Expect 30 to 45 minutes on a typical Burleson home.
Mice run the same routes every night. We use a thermal imaging camera to trace those paths through wall voids and set traps where the traffic actually is. This is why our catch rates beat a box of glue boards from the hardware store.
We place snap traps, glue boards, and tamper-resistant bait stations on the mapped run. Bait stations go in locked housings so kids and pets can't reach the rodenticide inside. Traps get checked and reset on a set schedule.
Once the interior is under control, we seal the outside. Copper mesh, hardware cloth, and sealant close gaps around pipes, vents, and foundation lines. This is the step that keeps the problem from coming back next season.
We remove droppings and contaminated insulation, apply disinfectant, and set a 14-day follow-up. On that return visit we pull traps, check the sealed points, and confirm the activity has stopped before we close the job.
Purpose-built equipment, used by trained technicians — so the job is done accurately the first time.
We use these to trace mouse runs through wall voids and attic insulation without cutting open drywall. It shows us exactly where the traffic is before we set a single trap.
A boroscope lets us look inside a wall cavity or foundation gap to confirm an entry point before we seal it. No guesswork, no unnecessary demolition.
Snap traps and glue boards go on the active run. We use both because some mice avoid one and not the other, and running both raises the catch rate.
Tamper-resistant bait stations hold rodenticide in locked housings so kids, pets, and non-target wildlife can't reach it. Required on commercial jobs and standard on residential.
Mice follow moisture. We check for damp spots in crawlspaces and behind appliances because fixing the moisture source is part of keeping rodents out long-term.
After rodent removal, we treat the attic and crawlspace for the fleas, ticks, and roaches mice bring in. Same visit, no extra trip charge.
A Burleson homeowner near 76028 heard scratching above the bedroom for three weeks. Inspection found droppings throughout the attic, gnawed HVAC insulation, and four entry points at the soffit line. The customer had already set six glue boards with no catches.
We mapped the run with a thermal camera, set 18 traps on the active path, and sealed all four soffit gaps with copper mesh. Traps caught 11 mice in the first 10 days. The 14-day follow-up confirmed zero activity.
A Burleson restaurant failed a health inspection with rodent droppings behind the prep line. The kitchen had a gap at the exterior pipe penetration that mice were using nightly. The owner needed documented proof of treatment before the re-inspection.
We sealed the pipe penetration, set six tamper-resistant bait stations, and logged every check. Droppings were removed and the area disinfected. The re-inspection passed with zero rodent findings 12 days later.
A pier-and-beam home in Old Town Burleson had mice in the crawlspace for months. The foundation vents were wide open with no screening, and the homeowner was finding droppings in the kitchen every morning. Two prior pest companies had only set traps.
We screened all nine foundation vents with hardware cloth, sealed the plumbing penetrations, and removed contaminated insulation. Traps caught 14 mice over the first two weeks. The kitchen has been dropping-free since.
Mice cause more damage than most people realize. Here are the four problems we get called about most often, and how we handle each one.
Ask a pro →We map the run with a thermal imaging camera, set traps on the active path, and seal the entry points feeding that void. Most customers stop hearing scratching within 48 hours of the first visit.
We pull the drawers, vacuum and disinfect the cabinet, and set traps behind the appliance line where the mice are traveling. Food-safe bait stations go in locked housings away from prep surfaces.
We inspect the attic for gnaw damage, treat the run with traps and bait stations, and seal the soffit and roof-line gaps mice use to get in. Contaminated insulation gets removed and replaced.
We treat the garage and crawlspace as the primary zone, seal the foundation and door gaps, and set exterior bait stations to intercept mice before they get inside. This is the same approach we use on commercial jobs.
$250 - $650 for most residential jobs; commercial quoted after inspection
Typical 2026 pricing for residential mice control in Burleson runs $250 to $650, depending on the size of the home, the number of entry points, and how much attic or crawlspace contamination needs removal. A single-room trap-and-seal job sits at the low end. Whole-house exclusion with sanitation pushes toward the top. Commercial kitchens and warehouses are quoted after inspection. We give you the price before we start, and we don't stack line items after the fact.
You're paying for exclusion work that stops the problem, not just traps that catch the mice already inside. A job done right the first time costs less than three repeat visits from a company that only sets bait.
Most Burleson homes have 6 to 12 gaps that need sealing. A home with 12 costs more than one with 6 because exclusion is the labor-heavy part of the job.
Tight crawlspaces and low-pitch attics take longer to work in. Difficult access adds labor time, which shows up in the quote.
Heavy droppings and soiled insulation require removal and replacement. A clean attic with light activity costs less than one that needs full sanitation.
A 1,500 square foot ranch is a faster job than a 3,500 square foot two-story. More square footage means more inspection time and more potential entry points.
“We heard scratching in the kitchen ceiling for two weeks before I called. The tech found where mice were coming in behind the dishwasher and sealed three gaps under the house. Traps were down for 12 days and we haven't heard a thing since. He also cleaned out the droppings in the crawlspace, which I wasn't expecting.”
Dana R.Homeowner, Old Town Burleson
✓ Verified“Called on a Tuesday morning about mice in the garage and had a tech out that afternoon. He showed me the entry points with a camera before sealing anything. Price was what he quoted on the phone, no add-ons. Two weeks later the follow-up confirmed no activity. Straightforward job, no pressure.”
Marcus T.Homeowner, Mansfield
✓ Verified“We needed rodent control that would hold up to a health inspection. They set locked bait stations, documented every check, and gave us a log we could hand the inspector. Mice were gone in under two weeks and we've stayed clean on every inspection since. Worth every dollar.”
Priya S.Restaurant Owner, Burleson
✓ VerifiedMost residential jobs run $250 to $650 in 2026, depending on how many entry points we seal and how much attic insulation needs replacing. A single-room trap-and-seal job sits at the low end. Whole-house exclusion with sanitation on a larger Burleson home pushes toward the top. Commercial kitchens and warehouses are quoted separately after inspection.
You trap the ones inside and seal the way they got in, in that order. Traps alone fail because new mice walk through the same gap within days. We set traps on the active run, seal every entry with copper mesh and sealant, then sanitize the droppings. Most Burleson homes are clear within 10 to 14 days.
The best mouse removal in Burleson TX combines licensed inspection, targeted trapping, and permanent exclusion. Anyone can sell you glue boards. The difference is finding the 6 to 12 entry points a typical home has and sealing them so the problem doesn't return. That's the work we warranty.
The first visit runs 2 to 4 hours for inspection, trapping, and exclusion. Traps stay down 10 to 14 days, and we return once during that window to check and reset. Whole-house jobs with heavy attic contamination can take three visits. You'll know the timeline before we start.
Scratching in the walls doesn't fix itself, and every week you wait means more droppings, more chewed wiring, and a bigger exclusion bill. Call (817) 426-4375 and we'll book a licensed technician for mice control Burleson TX, often the same day. Upfront pricing before we start.
Book an Inspection (817) 426-4375 →Call (817) 426-4375 or send us a message and we'll get back to you the same business day. We book same-day appointments for most jobs and run 24/7 emergency response for wasp nests, rodent issues in commercial kitchens, and bed bug discoveries. If you're not sure what you're dealing with, describe what you're seeing and we'll tell you what it probably is.